Dam glad your ok , possibly bullet setback during chambering of round . Or a little heavier than the 5.5 dropped, I'm not sure if a double charge of that powder would fit in a 9mm case as I have never used it.
I know them little casing aren't to forgiving I had one pop like that a few years...
You might be able to get them to chamber by running them through a lee factory crimp die or even a bulge buster. It would be at plucking all them bullets with a hammer puller.
Yeah shipping would take a bite out of the value for sure. Capital offers $1.40/lb credit and that rate hasn't changed in a long time.
Then I'm weary about the quality and safety of the fired casings you get back as you never know what kind of loads or how many times they have been fired...
https://polygunbag.com/product/50-cal-unfired-pull-down-brass-one-100-count-lot/
Poly gun bag has 1 batch of primed pulldown in there brass /odd lots section. I check them from time to time to see what they scrounge up. I got some 5¢ ..30 cal tracers from them once.
Occasionally they have some...
Just picked this one up it came with the EPT trigger which isn't bad but I'm looking to improve it some. Does anyone on here have experience with this particular platform or recommendations for a decent aftermarket Tigger.
I'm looking at this one from rise armament in the link below from Aim...
Those are looking good. Nothing better than a can full of rounds. I got some cans to fill up myself. I'm gonna try to work on that once the sun warms up the garage a bit.