Hendrick's no longer owns Old Glory. They built it, but got out last year.
I've stopped correcting people that pull that "old technology" bs. Basically the same thing as the mommies who cry about guns, but know nothing about them, and refuse to learn.
I appreciate people who get it, and...
They announced the closure last December. It was the least profitable dealership for Rommel's. I think its been gone for about 2 months now. It wasn't run well at the end.
There's nothing in the application that states the HQL must be pre-appproved to get the Designated Collector Status. Of course as you know you'll still need the HQL to buy a modern handgun, the DCS does not work in place of it.
But items like a regulated AR lower receiver that require a 77r...
I do believe you are correct. Here's one with a little less honest wear.
https://www.collectorsweekly.com/stories/58940-antique-belgian-breech-loading-target-ri
Guys I can speak firsthand of the awesomeness of Ryan & his services. I just closed yesterday on a house that's a huge step up for me, all because of the extreme efforts of Ryan & his team at Southern Trust.
I was fortunate to get a great rate locked in last month, and although we had many...
South Carroll is a great place, but only open limited hours as it's a side-gig. Check his IP forum for weekly updates. They will not be open if you go today at lunch, but hours have been posted for tomorrow. Really great IP, highly recommended.
https://www.mdshooters.com/showthread.php?t=242154
When i purchased my first Mosin, I was ridiculed by the older guys for paying $99 retail, and 15-16 cents a round for surplus ammo. They had only paid $29 a mosin when they stocked up, and 5 cents a round for the surplus ammo. "The deal was over, they're too expensive and not worth it", was what...
Then they should replace it. You followed the instructions and this was the unfortunate outcome. Good Luck, i've known a few people who didn't follow the instructions and were still helped out in the end by P80, they usually make things right.
Which operation did you do first, drill the holes or remove the chunks at the slide?
Although I agree with the break in advise (in general), you can clearly see that the extractor is way too proud, and there's no amount of break in that will fix that.
So with fees it sold for basically $620k. You've really got to have your batteries charged on your mental calculator at auctions like this with very high fees. There were numerous items at this auction that sold well below the auction house's estimate, but once you add in fees it hit their mark...
As the seller, that's all that matters. If the guy is legally allowed to buy an AR, he can go buy another one. You didn't change his status from being able to buy one. Your decision might have cost him a few hours and some gas money, but as the buyer from something off of armlist, he is also...
This was a common round for me growing up. It was really only used for one thing, and that was for self-defense (from poisonous snakes in the woods / rivers while working). It actually patterns faster and wider than you'd think out of a revolver, much wider in just a few feet than a .410. It was...
One our IP's asked me to please get a C&R because he was tired of running NCIS background checks on me for cheap surplus rifles (back when Mosins were cheap). He stated with an 03FFL, we could swap copies, fill out our log books, and i'd be on my way, saving both of us time and effort. He would...