2nd=Good+Substantial
Ultimate Member
I searched but couldn't find what I was looking for.
Once the anodized 80% lower is completed, do you put a finish on the bare aluminum? If so, do you paint the pin and selector holes or does the coating make the holes too small?
What is a good DIY coating (e.g. DuraCoat, AlumaHyde)?
Thanks!
Once the anodized 80% lower is completed, do you put a finish on the bare aluminum? If so, do you paint the pin and selector holes or does the coating make the holes too small?
What is a good DIY coating (e.g. DuraCoat, AlumaHyde)?
Thanks!