pop-gunner
Ultimate Member
- May 8, 2008
- 2,272
Loading a 200gr TCFP in 10mm.
This bullet.
https://missouribullet.com/details.php?prodId=243&category=20&secondary=11
At 1.25 OAL it feeds just fine from the magazine at slide lock in GLOCK 40 but will jam every time in Springfield TRP either using the slide stop to release the slide, or by slingshot-ing the slide.
I have tried seating the bullet as low as 1.23 but still can't get it to feed from the magazine in the TRP.
I don't want to go below 1.23 because of pressure concerns.
This was the load I was looking to replicate.
https://www.underwoodammo.com/colle...in-hard-cast-flat-nose?variant=18785723908153
Does anyone have experience loading that bullet in 10mm? If so at what OAL?
Does anyone have any of that Underwood ammo handy they could measure the OAL and see that they are using?
Thanks in advance...
This bullet.
https://missouribullet.com/details.php?prodId=243&category=20&secondary=11
At 1.25 OAL it feeds just fine from the magazine at slide lock in GLOCK 40 but will jam every time in Springfield TRP either using the slide stop to release the slide, or by slingshot-ing the slide.
I have tried seating the bullet as low as 1.23 but still can't get it to feed from the magazine in the TRP.
I don't want to go below 1.23 because of pressure concerns.
This was the load I was looking to replicate.
https://www.underwoodammo.com/colle...in-hard-cast-flat-nose?variant=18785723908153
Does anyone have experience loading that bullet in 10mm? If so at what OAL?
Does anyone have any of that Underwood ammo handy they could measure the OAL and see that they are using?
Thanks in advance...