So I had a couple questions about my build. I've learned the hard way on a couple things so far and wanted to get some more info before I move forward.
I'm building a Bulgarian AK74 that I got from AK Builder. I just got done heat treating the FCG holes and I need to trip up the ejector tip. When I run the bolt across the rails now the tip seems to snag just a little bit. How much should I trim off?
The magazine stabilizers need to be trimmed as well. Should I just make them even with the dimples?
My trigger guard needed to have the hole drilled and after doing so it seems to be off just a little bit. So my magazine catch is being an extra stone cold bitch. Any good ideas on how to get it back in there? I saw some stuff on using a vise and a slave pin. Should I rivet it in when I'm done?
Thank you in advance for any advice you give. Everyone on this site has been very helpful and courteous so far.
I'm building a Bulgarian AK74 that I got from AK Builder. I just got done heat treating the FCG holes and I need to trip up the ejector tip. When I run the bolt across the rails now the tip seems to snag just a little bit. How much should I trim off?
The magazine stabilizers need to be trimmed as well. Should I just make them even with the dimples?
My trigger guard needed to have the hole drilled and after doing so it seems to be off just a little bit. So my magazine catch is being an extra stone cold bitch. Any good ideas on how to get it back in there? I saw some stuff on using a vise and a slave pin. Should I rivet it in when I'm done?
Thank you in advance for any advice you give. Everyone on this site has been very helpful and courteous so far.