they are the polish ones
that doesn't answer the question, dingus. I don't spend my days scouring the internet for all things AK anymore...are the extractor cuts there? are the journals turned for RSB/GB/FSB? are they threaded?
they are the polish ones
If it's the same Radom barrel I bought, then it needs to be threaded, gas port drilled.
Extractor cut and journals are already done, to the best of my limited knowledge.
I'm undecided on the threading, a sporter contour just looks idiotic though (IMO).
Finally got some days off this week, so trying to get this kit fully de-milled and tie up all the loose ends on the receiver. Already bent, but haven't drilled it yet - don't trust the template/dimensions I got offline.
I'm undecided on the threading, a sporter contour just looks idiotic though (IMO).
Finally got some days off this week, so trying to get this kit fully de-milled and tie up all the loose ends on the receiver. Already bent, but haven't drilled it yet - don't trust the template/dimensions I got offline.
Guess the barrel may need to go off to a 'smith then.
Hadn't intended to suppress, but it is nice to have concentric threads - to have the option.
My little half-baked engineering paid off. Chopped, flared - just need to clean it up and it's ready for install/touch-up.
Still going to see if I can get this one finished up ahead of schedule. Still have plenty of work to do though.
Max would be proud
So close to being done. At least I know the light at the end of the tunnel isn't actually a train about to run my ass over.
View attachment 187249
Still have a few more things to wrap up, but we're finally on the home stretch. I'm going to have to start escaping MD to acquire more standard capacity mags...