Sam Salvati
blacksmith
Anyone have any real world e patience with one? Thinking of tradin in a couple pump actions for semi auto...
Anyone have any real world e patience with one? Thinking of tradin in a couple pump actions for semi auto...
I’ve been trying to trade for one for a couple years now, they are really rare to find on the trading market. I’ve shot a couple in some classes I’ve taken and they steal my attention everytime. Smooth, low recoiling and very ergonomic.
OMG, I am in love with this new shottie, and I haven't even shot it yet, and it did bite my trigger finger because I was being stupid.
The last two LTT 1301s I've seen on gunbroker went for 2450 and 2650, but there are lots of stardard 1301s on there for as low as 1000-1100.
I'd want to make sure I got a gen 2 model, but most say the "fatal flaw" of the gen 1 isnt as big a deal as it is made out to be. The gen 2s generally go for a few hundred more.
WAITING for pictures of the od green!!!
I've shot a couple. Uses the same inertia system (and is licenced from) Benelli, as used in the m1, m2 and m3 (m4 is gas operated)
Very smooth, and they shoot clean. well done.
My question is can you do the 7+2 trick like you can do on the M1 and some m2s? I.e. load the mag, float a round on the lifter and have one in the chamber?
Its not inertia its a gas gun.
Correct. It's gas driven similar to the Benelli M4. I actually has a slightly higher cyclical rate than the M4.
Its not inertia its a gas gun.
Don't know about the plus 2 trick, but don't think so.
Damn, I was thinking of the 1201FP. My bad.
In my defense, it was a while ago.