-Mil-Surp-Phreak-
Ultimate Member
I am thinking kind of outside the box I think and want to check with the hive mind before I try something. I have a Palmetto State dedicated .22lr upper https://palmettostatearmory.com/psa-8-5-22-lr-1-16-nitride-7-lightweight-m-lok-upper-with-bcg-ch6.html and building up my pre-2013 stripped lower as a Pistol. Am I able to use this UTG(I know cheap) adapter with a standard stock latch plate to hold rear takedown pin detent in and then my KAK Brace to get side folding? I don't need a buffer tube and spring as the .22lr upper uses the bolt itself as the recoil spring so it should work right? If it needs something to act as a stop for the .22lr bolt assembly I can mill something out of delrin or a cutting board to act as a buffer I believe. I've already ordered the part because it was only $15 so if it doesn't work no big loss but seeing if the collective mind had any thoughts on my idea. The LAW folding stock is cool and all but at $300 is almost more than my entire upper and is not needed since the .22lr bolt/adapter isn't reliant on the buffer tube and spring and buffer.