OK, i have a question. I recently got a milled rcvr MAK90, however i cannot stand the loophole stock. Anybody know where to get a different stock set. I know the MAK's are different on the rear of the rcvr. Thanks in advance
its easy to remove the stock. you'll have to buy a pistol grip and screw and a stock for a milled receiver. takes a few minutes to install. K-var sells them
http://www.k-var.com/shop/product.php?productid=17064&cat=251&page=1
I did the same with my post ban Arsenal
Good info but the kvar milled stock sets will not work on Milled Mak90's - the receiver is cut differently (the milled maks have an angled cut reciever - see the pic above).
Good info but the kvar milled stock sets will not work on Milled Mak90's - the receiver is cut differently (the milled maks have an angled cut reciever - see the pic above).
Here are your options for the Milled Mak. You can get an Ironwood Stock set and dress it up like this:
There is a ton of info on theakforum.net. That pic is from this thread in the Chinese subsection:
http://www.theakforum.net/phpBB3/viewtopic.php?f=15&t=163983
Your other option is to make it an Underfolder. Matt (aka Turbothis from www.gunsnorthwest.com) can help you out with that.
Good info but the kvar milled stock sets will not work on Milled Mak90's - the receiver is cut differently (the milled maks have an angled cut reciever - see the pic above).
Not if it was imported before 1989. At least that has been the stance of the ATF so far.