Problem with CX4 Storm 9mm

[ted70]

I took it to the range yesterday for the time. It shot great and functioned perfectly. The only thing that happened was, the takedown pin worked halfway
out. No big deal pushed it back in. I'm pretty sure that did not cause this problem.

When I cleaned the gun today, I noticed a nice little gouge in the bolt. It's in the grove the guide rod follows. Nothing is binding and it still seems to function fine. The rod just clears the part of the bolt that's dinged.

Should I send it back to Beretta? Should I take to someone local and ask them for their opinion first? This gun is new and I did clean it before I shot it yesterday. I'm 99.9% sure the bolt was fine before shooting it.

 

[EL1227]

Send it to Betretta ...

If it's that new, it's covered. Repair Turnaround Time: 4 weeks

Beretta USA Corp.
Service Department
17601 Beretta Drive
Accokeek, Maryland 20607
Phone: (800) 237 3882
(1-800-Beretta) Ext. 2003

 

[ted70]

Send it to Betretta ...

If it's that new, it's covered. Repair Turnaround Time: 4 weeks

Thanks

 

[TomisinMd]

Looks like in the third pic it was blued over a burr. I would think Beretta would change it out no problem.

 

[SuperMag]

Yeah, that came from the factory like that. If it were new damage, you'd see silver metal rather than a coated ding.

 

[ted70]

Thanks for the info. I called and emailed Beretta and they sent UPS to my house for pu. They received it on Aug 5th. Thanks again for the responses...