Remington 700 DBM plate install

[ThisGuy918]

Simple question that I have not been able to find the answer to. If I use this stock. http://www.hoguestore.com/index.php?main_page=product_info&cPath=654_671&products_id=5269 Would I still have to have the stock inleted to accept the magazine?

 

[herr.baer]

The DM denotes that it is for Detachable Magazine. As long as you had the correct bottom metal you would be good to go. Some of the thicker ones like the Badge may need some additional inletting.

 

[ThisGuy918]

I wasn't specifically speaking about the badger but I was leaning towards using it.

 

[herr.baer]

I just mentioned the Badger because it is one of the thickest and would require addition work. There are after market ones that aren't as thick that would be bolt and go.

 

[ThisGuy918]

Awesome. I might have to search around for an alternative to the badger to keep cost down on this build. I am sure I will still end up forking out the money for the AICS magazines.

 

[herr.baer]

http://www.brownells.com/.aspx/cid=...Model_1=Remington__700/Products/Bottom-Metals

 

[ThisGuy918]

I found an atlasworx but have never heard of them before. Report are spotty from the searching I have done. Most said it fits great and that was it.