platoonDaddy
Ultimate Member
Today I started a deep clean of my Gen2 G21, I was unable to remove the trigger with trigger bar. After closer examination the pin for the trigger safety wasn’t seated flush with the trigger. It might be the pin to attach the bar to the trigger, in any event that is the pin that needed reseated. In 20 years deep cleaning Glocks, this is the 1st time I had this issue.
I ended up putting pressure on the pin to reseat.
I have a complete 10mm, 45 & 460 Roland upper (slide with RSA & barrel) that I swap out from time to time. Maybe the pressure from the 10 and 460 caused the issue? !
Any words of wisdom?
Note attached picture, I have a red line highlighting the pin.
I ended up putting pressure on the pin to reseat.
I have a complete 10mm, 45 & 460 Roland upper (slide with RSA & barrel) that I swap out from time to time. Maybe the pressure from the 10 and 460 caused the issue? !
Any words of wisdom?
Note attached picture, I have a red line highlighting the pin.
Attachments
Last edited: