For anyone looking at this thread in the future...
I got a Grace USA Steel Roll Spring Punch Set from Amazon.
They are well built and the price wasn't too bad. Better than driving around hoping to find a set that isn't garbage.
I also got a Starrett Drive Pin Punch 8-Piece Set at the same...
They did two of my transfers. They were VERY helpful in getting both submitted as a pair and saving me additional wait time.
As for the range, it's the only range I've been to, but I've never had a problem. The folks up front usually nod and say hi as I walk back to the range. The range...
Continental Arms in Timonium had them in stock within the last month. But for me it was easier just ordering through the SA online store. They shipped mine quick and they have all the insert sizes available.
Not sure what the plan is, but before petitioning the Supreme Court for cert, there is the intermediate step of asking the Fourth Circuit for an en banc (all the judges) review.
Given that the Supreme Court may be hesitant to grant cert without any conflicting rulings among other circuits, and...
Even assuming the families agreed for them to be released, would you believe them? The ME has stated the autopsies showed .223 wounds. The police say they recovered the AR-15. If you think they are lying, won't you just think anything they release at this point is more lies?
Sorry to...
Not playing semantics, but my brother emailed me his gun safety piece yesterday and it was pretty good (and talked about "accidents"). So I figured I'd add it to this thread:
Anywho...
Thanks.
The light was actually the easiest bit to install. All it took was removing the Magpul MOE forend (using the wrench supplied). The MOE Illumination Kit includes both the switch holder and the rail piece that holds the light. Both of those pieces attach easily to the forend.
Very Nice. Yeah, your gun looks kinda familiar. :)
Having played with the Magpul MS3 sling, I think I'm going to stick to the single point setup using SGA receiver mount. It hangs well at across the chest/down the side of my leg.
The stock is really easy to work with. Loosen two screws and you can change up the cheek riser piece (comes with 3 choices) and add/remove spacers from the butt pad.