md_al
Active Member
Weber,
what freeze plugs should I get for a C cell tube? Are these available at Napa?
what freeze plugs should I get for a C cell tube? Are these available at Napa?
The tube will be 8.5 with the advanced endcap and a Gemtech lid that has had the threads moved back so it will fit in tube farther. I don't think the advanced endcap will add any length. I'm guessing it will be about 9.25 long
It seems that a B tube is best for 9mm. If I make a can for my scorpion, would it need a booster? Is there a way to make it so I can put a booster in line to then use on a pistol?
You can not have an extra end cap or thread protector legally unless you secure the internals without the ends holding the stack together.
I do have solutions for that but they require extra work.
So, do I want to get an MT2 for 45 degree and an MT3 for 60 degree?
http://www.amazon.com/gp/product/B00012YFKS/ref=ox_sc_act_title_1?ie=UTF8&psc=1&smid=ATVPDKIKX0DER
http://www.amazon.com/gp/product/B00012YFKI/ref=ox_sc_act_title_2?ie=UTF8&psc=1&smid=ATVPDKIKX0DER
BTW, the link for the center tool is not good any longer.
I think this is the new link. http://sdtacticalarms-com.3dcartstores.com/Centering-Tools_p_21.html
Thanks Weber. I bought both to play around with angles.
Wd is not going to help, you need to use a solvent that breaks the carbon down.
Two strap wrenches or one with the tube in a vice. If you can't get enough on it, then you can drill some holes to use a spanner wrench.
I have had some tighten up, but have always been able to get them apart.
Weber,
What is the best way to clip cones?
Carb cleaner it is then lol. Have to buy a strap wrench. Learned a lesson here, take it apart and clean it, or at least take it apart so it can be cleaned lol.
Strap wrenches are a must, get a good set of them. It's worth a few extra dollars for the good ones.