Angle head Dremel or one with a cable drill head attachment. Tapping isn't an issue with a standard tap tool.How do you drill and tap the case with the die in the press?????
Right angle drill...
And tapping?
Crescent wrench. Have you never been on a farm?
SO MUCH EASIER to just take the die out of the press.
But yes, I do know people that will spend 2 hours working around some issue, when it would take 15 minutes to remove the issue and get the work done in another 15 minutes
I hear about a lot of stuck cases with Hornady lube. It has to dry before sizing.
I hear about a lot of stuck cases with Hornady lube. It has to dry before sizing.
100% this. Let is dry enough and zero issues. I learned the hard way also. Since I let it dry, never had one stuck in 20k+ cases.
Ahh, good ol' One Stuck...
I went full redneck - gallon ziploc bag, 1/4 second shot of Pam - tumble bag, haven't stuck a case in almost 3 plus years now. (Hell of a lot cheaper too)
How much of a greasy feel is there when using the Pam?
I normally wear exam gloves while starting brass prep - so it's not anything that gets my attention, depending on how much brass is in the bag (and using a real quick shot of Pam), it's not greasy enough to become butterfingers.