Thank you!
Thank you!
That's not his; The Rifle Shoppe merely sells Hoyt barrels with some of their kits. The only ways to contact Mr. Hoyt are by phone, snail mail, or driving to his shop. He's done half a dozen barrels for me over the years, but can be tough to get in touch with. Just be persistent.
Updating: I have acquired a NOS 45-70 Numrich barrel for my project (I am not the OP). Thank you for the info that you have provided. Up-post I should have clarified, I can and would, if necessary, cut the threads myself. I know what the tool needs to look like etc. The problem if that my old lathe may not be up to the task. I have an old South Bend 9". When I was referring to "timing" of the threads, I was referring not to the timing of barrel to receiver but rather how the threading index on the lathe lines up on each pass. Old SB 9 lathes are notorious for not having the greatest thread timing, particulaly as they age. For cutting conventional V threads, it is best to always cut on the same number on the dial. V threads are very forgiving in thread "timing" or irregulality. Square threads are not. My friend rcently acquired a CNC lathe. We are going to program it to do square RRB threads and see how that goes.Yes the-yr out there and some people know how to do this sort of work even though its uncommon.
I was going to post up drawings for cutting tools and specific information for how to cut the threads last night, but now I think its not necessary.
Boring out the tenon and sleeving it to a new barrel would would be another option however that would be dependent on existing measurements of the old barrel stub and caliber choice intended by the owner.
And, quality of the work if the barrels already been changed once. Then again, it may not even have square threads.