SneakySh0rty
Active Member
That was an AoA kit? Did you try see if they'd exchange it out? I was thinking about ordering a few of them...
was an AoA kit but i think since everything is riveted in, i dont think i can just send back the barrel. Also, it may be user error during installation on my end. After cranking on it a bit more i finally got the bolt carrier to a point where i felt it didnt close on the no go gauge. I left the barrel pin in when i did this. It may seem like a bad idea, but i believe there was enough wiggle room to do it without removing it. Also, i was doing 8th of a turn increments. always checking the bolt and taking it out of the vice testing the bolt carrier. Took a lot of time, but it go there. Next build party in a few months, ill just repark it and hopefully have a second parts kit for my second build!